Step 01
Stick the mount on
Press the black square flat against the wall and hold it there a moment. It goes on flat and stays put.
Mounting
How it goes
on the wall
The mount sticks to the wall. The plate takes hold of the mount. That is the whole job, and it is over in about a minute.
No drillNo screwsNo measuringNo frame to hang
Step 02
Put the plate on
Bring the plate up to the mount and let go. The magnet takes it and pulls it flat to the wall.
Step 03
Nudge it straight
It slides on the mount, so straighten it by eye. No level, no pencil marks, no second holes.
This is the whole hardware
One flat black square. It ships with the plate, it goes on the wall first, and once the plate is over it you never see it again.
Because nothing is screwed in, the plate comes off as easily as it went on. Take it down for a move, lift it to paint behind it, or put it somewhere else in the house on a second mount.
- What holds it
- A magnetic mount. No need to screw or measure, it sticks to the wall.
- What the plate is
- A composite metal and carbon panel, printed edge to edge. No frame, no mat, no border.
- Sizes
- Front page 12 x 18 in · circle 15 in across · pennant 9 x 24 in.
That is it
No drill, no screws, no measuring, and nothing to level. If it is not quite where you want it, slide it. If you want it somewhere else entirely, lift it off and start again.
Back to the front pages